强震下混凝土剪力墙受弯模拟及测试实验研究          下载免费PDF全文

戴勤友  张正瑞 《地震工程学报》2020,42(2):337-344

为提高混凝土剪力墙受弯性能计算的准确度,开展强震下混凝土剪力墙受弯性能试验研究。选取1个混凝土剪力墙对比试件和3个测试试件作为研究对象,对试件施加垂直荷载和水平荷载,模拟强烈地震作用力。试验前期准备工作完成后,建立分离式有限元模型,通过计算混凝土在受压和受拉状态下的损伤弹塑性刚度,完成对有限元模型中混凝土塑性损伤分析,在此基础上,计算混凝土剪力墙受弯承载力。利用有限元模型对3个测试试件进行模拟试验,结果表明,强烈地震后3个试件的荷载-位移曲线均与实际位移值接近,且混凝土剪力墙受弯承载力试验结果与实际值的误差在2%以内,表明试验研究方法具有一定的可行性,数值模拟结果较为准确。  相似文献   

垂直地电场观测新技术的数据研究——基于坪城观测点的分析          下载免费PDF全文

周卫东  牛延平  叶青  田野  苏小芸  王娟 《地震工程学报》2020,42(4):914-918

结合同台观测的水平地电场数据,研究坪城垂直地电场观测数据,结果表明:(1)采用固体不极化电极进行垂直地电场观测,同一极距的观测结果基本一致,而铅板电极与固体不极化电极之间存在较大的电位差;(2)垂直地电场日变化形态清晰,长极距测道(A1C1、A2C1和A3C1测道)日变幅为5.85 mV/km左右,短极距(B1C1、B2C1和B3C1测道)日变幅为10.02 mV/km左右;(3)垂直向观测的地电场日变化优势周期在12 h和24 h。  相似文献   

2016年新疆呼图壁6.2级地震前b值异常特征研究   总被引：1，自引：0，他引：1       下载免费PDF全文

刘子璇  冯建刚  王维桐 《地震工程学报》2020,42(1):150-156

利用2009年以来中国地震台网中心地震编目资料,以2016年新疆呼图壁6.2级地震作为研究对象,采用最大似然法进行b值空间扫描计算,获取震前震中及其邻区地震b值的空间图像。研究结果显示,2016年呼图壁6.2级地震发生在震前显著低b值区域,该异常特征可能反映了地震孕育的应力积累过程,印证了b值的物理意义。  相似文献   

2019年长宁M_S6.0地震邻区分钟采样地电场分析     

王玮铭  谭大诚 《地震》2020,40(3):41-51

2019年6月17日四川宜宾市长宁县发生M_S6.0地震, 分析震中周边600 km内7个地电场台站观测分钟值数据, 获知震前2个月左右红格等6个台站地电场均存在不同方位之间、 同方位长短极距之间的相关系数持续降低, 6月17日这些相关系数基本降至最低, 反映出这6个场地的地电场在此次地震前后发生了非均匀变化; 同时, 这6个台站的地电场优势方位角出现了约45°或90°跃变, 并伴有显著发散或收窄现象。分析表明长宁M_S6.0地震前后, 这6个场地的多种地电场异常现象具有局部场地效应、 时间准同步性。  相似文献   

顾及地形起伏的无人机影像覆盖分析方法     

张衡  李骁  叶朋飞 《测绘通报》2020,(1):102-106

使用无人机实施测绘航空摄影时，由于无人机相对航高较低，地面起伏会对无人机影像的分辨率、覆盖范围、重叠度造成较大的影响，影像成果会出现分辨率不足、重叠度不够、覆盖漏洞等缺陷。针对这一情况，本文提出了一种利用数字微分正解法的计算方法，借助DEM准确计算每张影像的覆盖范围，并使用FME软件高效生成全部影像的覆盖范围。经过实际使用，验证了该方法可以在航线设计阶段准确预测并分析全部影像的覆盖范围、重叠度，因此可及时发现设计问题并调整航线。该方法可以有效减少因地形起伏造成的影像覆盖缺陷，减少返工现象，从整体上提高了作业效率。  相似文献   

资源三号和天绘一号卫星影像无控联合平差精度分析     

郑义  张宏伟  杜晓  张俊辉  周琦  林尚纬  陈利军 《测绘通报》2020,(7):10

近年来国产卫星传感器类型日益丰富，使用自主可控的国产卫星影像进行生产和研究的需求越来越大，多源国产卫星影像联合平差的精度分析显得尤为重要。本文针对在立体测图生产中，资源三号卫星影像在时相较旧、噪声较大、云覆盖和摄影漏洞等特殊困难的条件下，利用天绘一号卫星影像进行补漏生产的情况，最终分析并验证了两者无控联合平差的可行性和成果精度。  相似文献   

基于三维激光扫描技术的钢结构扰度检测及应用     

宋云记  王晓民  王智 《测绘通报》2020,(12):160-163

钢结构在长期荷载及不均匀受力的作用下会产生空间变形，其中扰度是其重要的衡量指标。通常采用全站仪采集钢结构轴线上若干特征点进行分析、计算，由于钢结构特征点难以捕捉，测量存在误差，并且有限的空间离散点难以全面反应钢结构空间变形。本文采用徕卡RTC360三维激光扫描进行钢结构扰度测量；介绍了其作业流程及数据处理方法；利用标靶将各个测站的三维点云拼接成一个整体；采用拟合的方法提取空间特征点及轴线；利用三维点云构建空间模型，并与设计模型进行碰撞分析；可全面地反映钢结构的空间变形情况。  相似文献   

Seismic reliability assessment and the nonergodicity in the modelling parameter uncertainties     

Fatemeh Jalayer  Hossein Ebrahimian 《地震工程与结构动力学》2020,49(5):434-457

Modelling uncertainty can significantly affect the structural seismic reliability assessment. However, the limit state excursion due to this type of uncertainty may not be described by a Poisson process as it lacks renewal properties with the occurrence of each earthquake event. Furthermore, considering uncertainties related to ground motion representation by employing recorded ground motions together with modelling uncertainties is not a trivial task. Robust fragility assessment, proposed previously by the authors, employs the structural response to recorded ground motion as data in order to update prescribed seismic fragility models. Robust fragility can be extremely efficient for considering also the structural modelling uncertainties by creating a dataset of one-to-one assignments of structural model realizations and as-recorded ground motions. This can reduce the computational effort by more than 1 order of magnitude. However, it should be kept in mind that the fragility concept itself is based on the underlying assumption of Poisson-type renewal. Using the concept of updated robust reliability, considering both the uncertainty in ground motion representation based on as-recorded ground motion and non ergodic modelling uncertainties, the error introduced through structural reliability assessment by using the robust fragility is quantified. It is shown through specific application to an existing RC frame that this error is quite small when the product of the time interval and the standard deviation of failure rate is small and is on the conservative side.  相似文献   

Efficient strong motion duration of pulse-like records for nonlinear structural analyses     

Constantinos C. Repapis  Petros P. Mimoglou  Vicky V. Dimakopoulou  Ioannis N. Psycharis  Ioannis M. Taflampas 《地震工程与结构动力学》2020,49(5):479-497

The special interest produced by near-field directivity records and their effect on structural response has given a new significance in the velocity time history, its pulse-like content, and relevant parameters and indices. Recent research has shown that directivity pulses inherent in these records govern the linear and the nonlinear response of a wide range of structures. Based on this observation, it is suggested in this paper that a truncated ground motion, limited to the duration of the predominant velocity pulse, can be efficiently used to predict the structural response, instead of the base motion with the total duration, reducing significantly the required runtimes. The proposed methodology is verified for a series of medium to high rise reinforced concrete buildings, for which nonlinear time-history analyses are performed for a vast suite of pulse-like near-field records applied as base excitations with their total duration and the proposed truncated one. Comparison of the results for the response displacements and forces shows very good agreement, permitting the acceptance of the pulse duration as the efficient strong motion time interval of the original record, which determines the response and, thus, it can be used for nonlinear structural analyses.  相似文献   

Talus slope geomorphology investigated at multiple time scales from high-resolution topographic surveys and historical aerial photographs (Sanetsch Pass,Switzerland)     

Hanne Hendrickx  Lars De Sloover  Cornelis Stal  Reynald Delaloye  Jan Nyssen  Amaury Frankl 《地球表面变化过程与地形》2020,45(14):3653-3669

Talus slopes are common places for debris storage in high-mountain environments and form an important step in the alpine sediment cascade. To understand slope instabilities and sediment transfers, detailed investigations of talus slope geomorphology are needed. Therefore, this study presents a detailed analysis of a talus slope on Col du Sanetsch (Swiss Alps), which is investigated at multiple time scales using high-resolution topographic (HRT) surveys and historical aerial photographs. HRT surveys were collected during three consecutive summers (2017–2019), using uncrewed aerial vehicle (UAV) and terrestrial laser scanning (TLS) measurements. To date, very few studies exist that use HRT methods on talus slopes, especially to the extent of our study area (2 km²). Data acquisition from ground control and in situ field observations is challenging on a talus slope due to the steep terrain (30–37°) and high surface roughness. This results in a poor spatial distribution of ground control points (GCPs), causing unwanted deformation of up to 2 m in the gathered UAV-derived HRT data. The co-alignment of UAV imagery from different survey dates improved this deformation significantly, as validated by the TLS data. Sediment transfer is dominated by small-scale but widespread snow push processes. Pre-existing debris flow channels are prone to erosion and redeposition of material within the channel. A debris flow event of high magnitude occurred in the summer of 2019, as a result of several convective thunderstorms. While low-magnitude (<5,000 m³) debris flow events are frequent throughout the historical record with a return period of 10–20 years, this 2019 event exceeded all historical debris flow events since 1946 in both extent and volume. Future climate predictions show an increase of such intense precipitation events in the region, potentially altering the frequency of debris flows in the study area and changing the dominant geomorphic process which are active on such talus slopes. © 2020 John Wiley & Sons, Ltd.  相似文献